signaled by a pulsing of the Tx diode.
The switching of the relay 1 - 4 on causes the lighting of the AL1 - AL4
diode (g. 4).
5.3
Installation of CO M Port Controllers in the Computer
Before conguring the transducer, the driver on the CD should be in-
stalled. The transducer makes use of the software, which creates
in the system, a device of Universal Serial Bus –
Multi-transducer
and
connected to it, the virtual COM port named
Multi-transducer
.
The controller installation in the Windows system causes the addition of
a successive serial COM port to the list of ports serviced by the operat-
ing system.
After connecting the transducer to the USB port, the operating system
informs about the appearance of a new device by means of the message
presented on the g. 5.
The creator to nd a new hardware of the Universal Serial Bus will be
started automatically. One must act in compliance with the creator sug-
gestions, choosing the installation from the indicated location and giving
the path to controllers being in the added CD.
Controllers are compatible
with following systems: Windows 2000, XP, Server 2003, Vista, server
2008, (x86 and X64). When installing controllers, information about the
lack of the controller digital signature can occur. One must ignore this
information and carry on the installation.
Fig. 5. Message signaling the detection of a new device “Multi-transducer”
Multi transducer
14
14
Summary of Contents for CON-M 22
