Section 4. Programming
4-7
operator does not enter the digits of the new code correctly or forgets what they are before
using the code again, then there is no way to get back into the program mode again except to
force the panel to its default settings. This will also require that you reprogram the rest of the
unit’s memory as well.
DCS Encode Polarity
This command allows the service technician to invert the polarity of the DCS encode in
software. This may be necessary to make the transmitted data stream look correct for the
decoders in the mobiles using the system.
215#
DCS Encode set to Normal Polarity (default)
216#
DCS Encode set to Inverted Polarity
DCS Decode Polarity
This command allows the service technician to invert the polarity of the DCS decode in
software. This may be necessary to make the received data stream from the mobiles using the
system look correct for the decoder in the Model 37-MAX.
217#
DCS Decode set to Normal Polarity (default)
218#
DCS Decode set to Inverted Polarity
Exit the Program Mode
Returns the Model 37-MAX to the normal operating mode.
99#
Exit Program Mode
Summary of Contents for 37-MAX
