Section 5. Installation
5-30
Connections to a Uniden ARU-251K Repeater
For:
Zetron Model 37-MAX
To:
Uniden ARU-251K
Using:
709-7179 Generic Radio Cable
37-MAX End
Function
J1
pin#
Wire
Color
Radio End
Connection/Notes
+12 volts DC
1
RED
Pin 6
Ground
2
BLACK
Pin 8
Discriminator Input
3
WHITE
Pin 8
Ground
4
BRAID
No connection
TX Audio Output
5
BLUE
Pin 7
Ground (spare)
6
N/C
PTT Output
7
ORANGE
Pin 1
Ground
8
BROWN
Pin 8
COR Input
9
YELLOW
Pin 2
CTCSS/DCS Encode
10
GREEN
Pin 9
Uniden ARU-251K Configuration
1. Install a wire jumper on the accessory jack between pin 4 and pin 5 (Audio Amp Out to
Speaker In).
2. Disconnect the Tone Encode lead from the Exciter at FT18 on the Exciter case, leave the
wire disconnected.
3. Attach a wire from FT18 on the Exciter case to pin 9 on the accessory connector. This
provides a path for the CTCSS encode from the tone panel to the transmitter exciter.
4. Set the Control Board switch to Carrier Squelch position.
5. Set the Front Panel switches to Local and Monitor.
Summary of Contents for 37-MAX
