5-1
5. INSTALLATION
INSTALLATION WARNING
This equipment generates, uses, and can radiate radio frequency energy. If not installed and
used in accordance with the instruction manual, it may cause interference to radio
communications. Installation of the Model 37-MAX should only be attempted by qualified
radio service personnel.
GENERAL
Connections to the transmitter, receiver, and power supply are grouped on a detachable
connector on the rear of the unit for ease of installation. The Model 37-MAX includes
installation test modes to aid in installation. Adjustments can be made from the rear of the
Model 37-MAX, though the top cover will need to be removed during the initial installation
to allow the technician to check and set the positions of various jumpers.
The “Installation Procedure” in the beginning of this section is generic in nature. The “Radio
Specific Application Notes,” at the end of this section, will aid the technician considerably in
connecting the Model 37-MAX to the radios to which they apply.
EQUIPMENT REQUIRED FOR INSTALLATION
Equipment
required
for the installation includes :
Communications Service Monitor
DTMF capable mobile radio or handheld transceiver
Soldering iron, and solder
Shielded Audio Cable
Hookup Wire
Volt meter (preferably one with DC, AC-rms, and dBm scales)
Crimping tool for adding the Model 37-MAX connector pins to the hook-up wire
Additional
recommended
equipment:
Oscilloscope
Summary of Contents for 37-MAX
