Q-1
QUICK REFERENCE
Error! Unknown switch argument.
OVERVIEW
This quick reference is provided as convenience for experienced technicians. Very little is
explained here. If information provided here is not clear, refer to Section 4 for more complete
descriptions.
PROGRAM MODE ACCESS
The programming mode can be accessed by entering the Program Mode Access Code over
the radio. The default value for the Program Mode Access Code is “12037”. The Model 37-
MAX will respond to decoding a valid access code by transmitting a “go-ahead” tone
consisting of five short beeps. If the access code decoded by the 37-MAX is invalid, then the
panel will ignore the attempt.
ENTERING A PROGRAM COMMAND
To enter a programming command, a DTMF number is entered followed by the “#” key.
Once the “#” has been entered, the Model 37-MAX will respond either with the 5-beep “go-
ahead” prompt to indicate the command was accepted, or the high-low “error tone” sequence
to indicate that an invalid command sequence was received.
Some commands will require additional numbers be entered. When it receives a command of
this type, the 37-MAX will respond with two quick beeps to indicate that it is waiting for the
additional data. In most cases, the data will be followed by a “#”.
The Model 37-MAX accepts its commands and updates its database in “real time”. The
programming mode can be exited at any time and the panel will “remember” any and all
changes made up to that point.
The commands should all be entered one at a time, do not try to string several commands
together in a single transmission. If the next command is not received within 60 seconds of
the last command, the 37-MAX will exit the programming mode and return itself to the
normal, idle condition.
EXITING THE PROGRAM MODE
When a programming session is completed, the programming mode is exited by entering
“99#”. The 37-MAX will transmit a prompt that sounds like the ringing of an electronic
telephone, and then return to its normal, idle state.
If the Model 37-MAX receives no new commands for a period of 60 seconds, it will exit the
program mode and return to the normal idle state on its own.
Summary of Contents for 37-MAX
