9
SAFETY INSTRUCTIONS FOR USERS
Please, pay increased attention to the
parts of the Operator’s Manual that are
marked with this symbol.
This symbol accompanies all
important warnings that concern
operation safety.
Observe these instructions
and be extremely careful in
these cases!
Inform your colleagues and
other users about these
warnings.
Carefully study the chapters
marked with this symbol before
starting to perform operation,
repairs and adjustments of your
tractor.
This symbol identifies all
important information concerning
operation, adjustment and
repairs of the starter motor.
Observe these instructions
and be extremely careful in
these cases!
This symbol marks parts of the
Operator’s Manual concerning
environment protection. Or
possibly sections describing
handling of dangerous waste.
∗
This symbol refers to optional
tractor accessories installed by
the manufacturer on the
customer’s request.
Accessories that are not
installed by the manufacturer in
the standard way or * optionally
on the customer’s request (in the
production plant) cannot be
subject to a claim.
GENERAL SAFETY REGULATIONS
1.
The tractor may only be operated by
a trained person that has a valid driving
licence and has been thoroughly
acquainted with the operation and safety
rules.
2.
Besides the safety instructions
mentioned in the Operator’s Manual you
are obliged to respect generally valid
safety and traffic rules of the country
where the tractor is used.
PROPER CLOTHING
3.
Do not wear loose clothing and free
flying long hair.
4.
During all work use suitable
(prescribed) means of personal
protection (working boots, gloves,
goggles, etc.)
STARTING THE ENGINE
5.
It is not permitted to start the engine
by driving down a slope.
6.
The tractor may be put in motion to
start the engine with the use of another
tractor or another vehicle with the use of
a towing bar only.
7.
Only start the engine from the driver’s
seat with the clutch pedal fully
depressed.
Life hazard when starting by
means of short-circuiting the
starter terminals!
8.
The key in the switch box must be in
the “I” position.
9.
When heating the engine with the *
electric heater first plug the power supply
cord to the heater and only then to the
electric mains. After the end of heating
first disconnect the heater from the
electric mains.
Caution! Electric shock hazard!
Summary of Contents for FORTERRA 95
