Zetor FORTERRA 95, Operator'S Manual

Page: 174 / 197

174
ADJUSTMENT
F291 F_02_142 F_2_132
REPLACING BRAKE SEGMENTS OF
THE FRONT CARDAN BRAKE
The brake segments must be replaced
if the lining thickness drops to 2 mm.
The brake segments are accessible af-
ter removing of the two locking pints
that secure the covering metal sheet.
Wear of the brake segments of the
Cardan brake is signalled by the indi-
cator on the dashboard.
Note: The brake lining of the Cardan
brake contains contacts that connect
the electric indicating circuit when the
lining gets worn.
ADJUSTMENT OF THE LIFTING DRAW-
BARS OF THE HITCH FOR A SINGLE-
AXLE SEMI-TRAILER
−
Raise the hydraulic arms to the upper -
transport position with the position control
selected and the vibration compensator off.
−
Screw the nuts on the adjustable draw-bars
towards the guiding pipe without any play.
−
Tighten the nuts by another 4.5 turns.
−
Check whether it is possible to tilt off the
supporting hooks freely.
−
By lowering and repeated lifting of the hy-
draulic arms to the transport position check
whether the engine does not tend to “stall"
at the idle speed - the relief valve of the hy-
draulic pump must not be in operation.
−
Then, lower the arms slightly.
ADJUSTING THE BOWDEN CABLE
It is performed if the carrier with the
towing hook is in contact with the sup-
porting hooks. The Bowden cable must
be tensioned to avoid any play of the
control lever in the cab. Then, the ca-
ble is secured against loosening with a
nut.