Zetor 106 41 forterra turbo, Operator'S Manual

Page: 141 / 257

141
HITCHES
F195a F196
BLOCKING THE SIDE SWINGS OF THE
LOWER TIE RODS
Insert the pin (1) into the hole II (imple-
ments of the category II). The hitch is set
in the middle position. A fine setting of
the hitch can be carried out with the help
of the bolt (2). The blocking of the tie rod
side swings is used for transporting the
attached implements and for those ma-
chine which require accurate guiding
behind the tractor.
In the reinforced three-point hitch it is
possible to adjust the limiting tie rods
smoothly with a slewing collar within the
whole range.
The tractor must always be fitted with the two limiting tie rods with pins
equally adjusted – both of them unblocked or blocked up. When operating
with the implements of the category II. which may require the side swinging
(for instance a plow) do not set the rear wheel spacing to less than 1500 mm
to avoid collisions of the lower tie rods with tires. For the drive without any im-
plement connected , the lower tie rods have to be joined with springs, while
the upper tie rod shall be placed into the sprung suspension.