Zetor 106 41 forterra turbo, Operator'S Manual

Page: 69 / 257

69
DRIVE OPERATIONS
STARING THE ENGINE FITTED WITH GLOW GRATINGS
1. Insert the key into the key switch. Check turning off the PTO switches on the right
pillar of the tractor cab.
2. Depress the clutch pedal.
3. Move the main shifting lever and reversor lever into neutral.
4. Turn the key through "I" position into "II" position and (start) crank the engine only
(when “hot starts” this point can be eliminated).
5. Turn the key to the “I“ position.
6. In case of yellow glowing signal light on the dashboard just short flash, means
thath temperature of cooling liquit is worm enough and the glowning is not
needed (skip point 7.). In case the glowing yellow signal flashes 3x for 2 sec, is
necessary to use the glowing.
7. By push button with symbol of glowing on the dashboard, you activate the glow-
ing. A yellow light is switched on. You have to wait until glowing signal switching
off.
In case the glowing signal light instead of switching on just flashes with
pause, there is a failure in glowing systém. Have the failure signaled repaired
in the profesional service center.
Note: the glowing push button press just one only. Furter push you switching
off glowing.
8. Turn the key into "II" position (start).
9. Release the key immediately after starting the engine.
Do not start longer time
then 10 sec .
10. After starting the engine, avoid running the engine at high speed.
11. After the engine start and by the glowing signal lights switching on show us up to
glowing engine. Between 1,5 and 7 minutes the glowing signal light switche off. If
the glowing signal light not flashes after the engine start,by come large amount
curent consuption by the engine start the glowing automatic switches off.By push
button with symbol of the glowing on the dashboard you activate up to glowing
the engine.