19
Example №1: The digital inclinometer is mounted at the controlled element of a structure,
which is located in position, in relation to which it is necessary to control the tilt angle. Select the
option “Off” in the field “Offset”, save the settings, wait for stabilization of digital inclinometer
readings (for ratio α=0.005 the stabilization time is approximately 15 minutes – you can visually
control the stabilization process with the use of the program “multichannel oscilloscope” from the
scope of ZETLab software). Then select the option “On” and save the settings again. The digital
inclinometer will start recording the change of the tilt angle in relation to the set zero value.
Example №2: In order to measure the absolute angle, set the digital inclinometer at even
horizontal surface, configure the settings so that to take the offset into consideration (see Example
#1), then place the inclinometer at the controlled surface and measure the angle.
