14
4.2
Functions and composition of the tabs used for configuration of measuring part of the
digital inclinometers
Digital transducer consists of two channels (by default, the names of the channels are: “Axis X” and
“Axis Y”). It is possible to configure parameters of the digital transducer only in the tab of the channel
“Axis X”. As the parameters of the channel “Axes X” are changed, the system automatically applies
the corresponding changes to all other channels.
4.2.1
The tabs «Axis Х» and «Axis Y»
Digital inclinometer ZET7х54 contains two mutually transverse channels X and Y. The tabs
“Axis X” and “Axis Y” contain information of the channel parameters, that are further specified in
Table 4.1
.
Table 4.1 Parameters of the tab “Axis X”
Parameter
Possibility of
configuration
Admissible
values
Description
Current value of the
channel (in
measurement unit)
−
Within the
measurement
range
Displays the measured value of the
channel (at the moment of tab activation)
Refresh rate, Hz
−
−
Depends on the value selected for the
parameter
«Conversion frequency» of the
«Sensor» tab
Measurement unit
−
−
Corresponds to the current measurement
unit
Name of the
channel for axis Х
(or Y)
Yes
Any sequence of
symbols
(max 32)
The parameter is set arbitrary. For the
first channel it is recommended to use a
name with the symbol “X” (and with the
symbol “Y” for the second channel
respectively)
Minimal value (in
measurement unit)
−
−
The section contains the minimal
possible value that can be measured by
the digital inclinometer.
Maximal value (in
measurement unit)
−
−
The section contains the maximal
possible value that can be measured by
the digital inclinometer.
Reference value for
calculations, dB
−
−
Displays the reference value used for
calculation of the measured values in dB
Sensitivity (in
measurement unit)
−
−
Displays the sensitivity value (the
parameter is not applicable for
inclinometers of ZET 7х54 series)
Sensitivity threshold
(in measurement units)
−
−
The parameter specifies measurements
precision
