The Zeroplus Logic Analyzer
Installation Guide
The Zeroplus Logic Analyzer Installation Guide
Page 30
Fig 3-25 – Trigger Column
2. Set Binary, Hexadecimal or Decimal as the signal of the bus to represent
the value(see Fig 3-24).
3. Set “= =” and type the value of bus into value column to set the trigger
condition of the bus.
4. Click OK,
Step 4.
Click run and activate the signal from the tested board to the system to get
the result as shown in Fig 3-26.
Tip:
Click
icon to view all data, and then select the wave analysis tools to
analyze the waves.
Set Value is 5E as Hexadecimal, and set Operator equal to “= =”, then click
OK, Click run and activate the signal from the tested board to the system to
get the result as the trigger happens on 0X5E.
Fig 3-26 – Bus Trigger Setup
Summary of Contents for LAP-321000U-A
Page 1: ......
