The Zeroplus Logic Analyzer
Installation Guide
The Zeroplus Logic Analyzer Installation Guide
Page 28
3.2 Bus
Logic
Analysis
Section 4.2 presents detailed instructions about logic analysis with a set of grouped
signals, which is known as Bus Logic Analysis.
Basic Software setup of the Bus Logic Analysis
Step 1.
Set up the RAM size, Frequency, Trigger level and Trigger position as
described in Section 3.1.
Step 2.
Group Signals into a Bus
Click Channels setup on Bus/Signal of menu bar, or click
icon.
The dialogue window shown in Fig 3-21 will appear.
Fig 3-21 – Channel setup
Rename the bus and set up the signals of the bus as shown in Fig 3-22.
Fig 3-22 – Renaming Bus
1. Click the column with blue, then type the given name of the bus, and then
press enter to confirm it.
2. Go to the relative channels show as shown in the example and, go to
numbers 1,2,3,4,5 which are located on column A and row Bus1. Click
them, to become purple, to set these segments of signals.
3. Click OK to get the result as shown in 0 area 1.
Summary of Contents for LAP-321000U-A
Page 1: ......
