Zero Motorcycles FX 2022, Owner'S Manual

Page: 85 / 164

General Maintenance
6.13
Parking Brake (if equipped)
If your motorcycle is equipped with a parking brake, it should
prevent the rear wheel from rolling when the lever (located on
the handlebar) is in the ON position. If the rear wheel can roll
when the parking brake is applied, it should be adjusted as
follows.
Parking Brake Adjustment
1. Support your motorcycle on a stand with the rear wheel off
the ground.
2. Position parking brake lever in the OFF position.
3. Insert a screwdriver into the slot on the end of the cable (A)
to prevent it from rotating.
4. Gradually tighten adjustment nut (B) while rotating the wheel
until you can feel drag on the brake rotor.
CAUTION: Do not over-tighten the parking brake cable as this
can cause premature brake wear.
5. Operate the parking brake lever ON and OFF to check
adjustment. With the lever applied, you should not be able to
rotate the rear wheel.
6. Re-adjust the parking brake if necessary.
7. Remove your motorcycle from the stand.
Zero Owner's Manual (FX and FXS).book Page 13 Thursday, May 13, 2021 10:53 AM