Zero Motorcycles FX 2022, Owner'S Manual

Page: 105 / 164

General Maintenance
6.33
Parking and Long Term Storage
•
Whenever you plan on not riding or storing your motorcycle
for extended periods of time (more than 30 days), it is
recommended that you charge the power pack to
approximately 60% state of charge (SOC) and then leave the
charger disconnected.
•
If the key switch has not been in the ON position within the
last 30 days, the Battery Management System (BMS) will
activate long term storage mode which will automatically
drain the battery to 60% SOC. If the motorcycle is connected
to the charger while in long term storage mode, the maximum
SOC will be limited to 60%.
•
The power pack will discharge extremely slowly over time.
Check the SOC at least monthly and charge it back up to
60% if it has dropped below 30%.
•
To prolong the life of your power pack you should store your
motorcycle in a cool area. Storing your motorcycle in a hot
area will cause your power pack’s life to be shortened. The
recommended storage temperature is -4°F (-20°C) to 95°F
(35°C).
•
When you’re ready to take your motorcycle out of storage to
ride it again, turn the key switch to the ON position and back
to OFF to exit long term storage mode. Charge for at least 24
hours to ensure optimal cell balance is restored.
For more information on the power pack and the electrical
system, see
page 5.1 .
WARNING! Opening of the power pack is for trained Zero
Motorcycles technicians. Please be aware that incorrect
handling of a Zero power pack can be dangerous. DO NOT
OPEN!
Zero Motorcycles Accessories
Zero Motorcycle accessories are designed to complement and
function with other systems on your motorcycle. Your dealer can
accessorize the motorcycle using genuine Zero accessories.
A full line of parts, accessories, and apparel can be found on
the Zero Motorcycles website.
Fuses
Whenever there is an excessive amount of current flowing
through a circuit the fusible element will melt and create an open
or incomplete circuit. Fuses are a one-time protection device
and must be replaced each time the circuit is overloaded.
Replace the fuse with one of equal current and voltage rating. If
the fuse melts repeatedly, have the electrical system inspected
by your dealer.
To access the 12 volt fuse center and the ABS fuse, the RH front
body panel has to be removed.
Zero Owner's Manual (FX and FXS).book Page 33 Thursday, May 13, 2021 10:53 AM