DMX Input
JesterML Operating Manual
73-406-00 Issue 2.0
39 of 73
•
Return to the main Setup menu, and scroll down to find the
DMX Input Setup
menu. In this menu, set the
Wing Width
to 24.
•
Return to the main Setup menu, and hold
MODE
for a few seconds to leave
Setup.
Testing the Setup
•
Put the JesterML into Preset Mode. Set the A Master to full, and the B Master
to zero. Raise the Grand Master to full, and ensure that Blackout is not active.
•
On the JesterML, press the
Page B
button so that the bottom LED is lit and
the
STORE
button lights up orange.
•
On the JesterML, make sure that
A FADERS, B STORED
is displayed on the
main LCD, if not, press the
STORE
button so that it is.
•
Move the channel faders on the Jester24/48 to fade the channels up and
down. The results can be seen on your dimmers, and on the monitor screen
connected to the JesterML.
•
When programming, all operations are performed on the JesterML. Only the
preset faders are used on the Jester24/48.
Saving Shows
All show data is recorded on the JesterML, and so shows should be saved to a USB
memory stick from the JesterML. You may save the default setup of the Jester24/48
too if you wish, but there is no real need since this will only contain the default 1:1
patch on that desk.
Memories & Submasters on the JesterML will include the preset channels recorded
from the Jester24/48. Other channels from the DMX Input are ignored and not
recorded – in this simple setup these will all be at zero anyhow.
