Zero 88 ConTour 12, Installation Manual

Page: 36 / 40

Test Mode
The Contour has a large number of inbuilt tests. The
majority of these are for factory or dealer use and so are
not documented here. Full inbuilt test instructions are
supplied to main dealers.
To Enter Test Mode
Press and hold the four START CHANNEL, TOP SET,
PREHEAT and LAW buttons.
When Test is entered, the display will show ‘0nn’ with the
‘0’ flashing - ‘nn’ is the last two digits of the
communications processor software version number.
To Exit Test Mode
Press and hold the three START CHANNEL, + and -
buttons. The display will be blanked.
The Test Mode will be exited when the START
CHANNEL button is released.
To Select Test
Use +/- to select the required tests. Press + and -
together to select ‘0nn’ - version number display.
Press the + button to selects:
0nn Version number display
x@y Option Selection
1, 2, 3 Factory / Dealer Use only*
4 Display internal analogue
data references
5, 6, 7, 8, 9 Factory / Dealer Use only*
* These are internal Contour tests.
0nn Version Display
The ‘nn’ indicates the latest communications processor
software version.
Press any CHANNEL button to latch that channel to
100% and turns off all other channels; pressing any
CHANNEL button with one that is currently at 100% held
brings the new channel to 100% as well.
x@y Option Selection
The three digits of the display are programmed as
follows:
First digit
x
Second digit ‘2’ and ‘3’ flashing alternately
to form a crude @ symbol
Third digit y
Use a CHANNEL button to select the option to view. The
channel light will come on and ‘x’ will display the option
number.
Press the CHANNEL button again to toggle between the
option set (1) / not set (0).
Options are:
Option Enabled
Disabled
Temp Sensor 1@1 1@0
fan forced on
DMX input 2@1
2@0
Front panel 3@1
3@0
Any options offered except 3 will be reset to ‘x@1’ when
the dimmer is powered off and back on.
Front Panel Disable is fully described earlier in this
manual.
Display Internal Analogue Data References
Press the channel number for the following data:
1 Temperature sensor 1 raw input data
2 Temperature sensor 2 raw input data
3 DMX fade/hold slide switch data
4 Mains voltage [a]
5 Fan voltage [b]
6 Actual temperature (°C)
7 Chase OK information [c]
8 Phase number information [d]
9 Nominal dimmer operating voltage [e]
10 Fan PWM control [b]
Notes:
[a] Mains Voltage
Shows the mains voltage (Vrms) as read by the
processor. It should nominally be 110 or 230.
[b] Used by Zero 88 Test Department only.
[c] Phase OK Information:
Display Phase 1 Phase 2
Phase 3
000
001 OK
002 OK
003 OK OK
004 OK
005 OK OK
006 OK OK
007 OK OK OK
[d] Phase Number Information
Display Information
000 Unknown number of phases
001 Single phase
002 Three phase
003 Not Used
[e] Nominal Dimmer Operating Voltage
Display Information
‘000’ Cannot determine operating range
‘110’ 90 - 130 V
‘230’ 180 - 260 V
Test Mode Information
Page 34
7363400/Issue 1/June 00