Z 45/75-90/110
34
Installation
www.zepro.com
4.13
Adjusting the tilt angle
NOTE!
Do not adjust the cylinders before they are fitted to the
platform. The tilt cylinders are preset from the factory.
1. Loosen the rubber bellows at the bottom where
they are secured with hose clips.
2. Run tilt-up until both tilt cylinders are fully raised.
NOTE!
Always make adjustments with full hydraulic
pressure in the tilt cylinders.
3. Undo the locking nut.
4. Turn the pushrod so that the platform comes into
the desired position. On vehicle bodies without rear
doors, the platform is to be adjusted in toward the
side sealings. On vehicle bodies with rear doors,
the platform is adjusted so that it stops in a verti-
cal position with a sufficient gap between platform
and doors.
Out
In
Body without rear doors.
With side seals.
Body with rear doors.
+
Image 48. Adjusting the fit to the vehicle body
Image 49. Adjusting the fit to the vehicle body
Summary of Contents for Z 45-90
Page 2: ......