Z 45/75-90/110
24
Installation
www.zepro.com
8. Fit the upper part of the bracket onto the lower part.
Installation must cover at least 6 of the holes on the
row on the lower bracket. Use the four M14x45 bolts
supplied. Install without tightening. See Image 23.
9. Check the C and D dimensions.
10. Align the chassis bracket on the vehicle chassis.
Adjust these positions along the support frame
if needed.
11. Drill 14 mm holes in the vehicle chassis, centred
in the holes in the bracket.
12. Fasten the chassis bracket to the vehicle chassis.
Use the M14x45 bolts supplied. Use at least 4 bolts
in each chassis bracket. See Image 24 for location
of bolts. Tightening torque 120 Nm.
13. Tighten the bolts that hold the two parts of the chas-
sis bracket. Tightening torque 120 Nm.
14. Tighten the bolts that hold the chassis bracket to
the support frame. Tightening torque 120 Nm.
NOTE!
Welding is not permitted on the chassis brackets.
Do not run the lift all the way to the arm stops or
with the platform fitted before all the bolts are fully
tightened to the chassis.
Do not place the lift under load until:
the correct number of bolt have been installed
and torque tightened.
the body is mounted to strengthen the
truck frame.
15. Remove the mounting jig.
For other chassis brackets, see the respective directions.
Image 23. Fit the upper part of the bracket onto
the lower part. Installation must cover at least 6
of the holes on the row on the lower bracket.
1
2
3
Image 24. Fasten the chassis bracket to the ve-
hicle chassis. Locations 1 and 2 are recommend-
ed, location 3 should be avoided if possible.
At least 4 bolts
M14x45 10.9 (120 Nm)
6 bolts
M14X35 8.8
(120 Nm)
At least 4 bolts
M14x45 8.8 (120 Nm)
Image 25. Fitting the chassis bracket.
Summary of Contents for Z 45-90
Page 2: ......