45
9. Slide the jack barrel along the wire and over the jack. Screw it on tight. Take the jack out of the
clamp or vise.
156
10. Unscrew the barrel of the other jack (Part # JA07) and slip the barrel over the wire so it can be
screwed on to the other jack after you solder it, and then slip the little plastic sleeve over the wire
as well.
157
11. Repeat Steps 3 through 9 for the second jack.
158, 159
12. Double-check all the solder connections: make sure they are sound and secure, and that there are
no stray strands of wire loose anywhere. Fix it now.
13. Test the continuity of the cable with your multimeter. Set your meter to the continuity setting (or
Resistance setting). Test across the tips (the positive points) for continuity. A continuity tester will
beep; a resistance meter should show very low resistance, like, less than one ohm. Next test
across the two shafts (the negative points) for continuity. Now, test from one positive point to
the opposite negative point for dis-continuity! No beep, infinite resistance. Last, check the other
156
157
158
159
Summary of Contents for 1x8 Cabinet
Page 52: ......
