16
18. Fit your drill with the 1/16” bit, sticking out about 1-1/8”. At the corner you lined up, drill two
holes at the nail/awl marks, through the side, and into the mated wood piece.
34
19. Continue to the other three corners, loosening the clamps and lining up the corners one by one.
35
Drill a total of 8 holes.
20. Disassemble the four pieces. Still with the 1/16” bit, drill four blind pilot holes about ½” deep in
the Bottom where marked
36
, and four holes ½” deep around the Port jack hole.
37
Do not drill the
holes at the ends of the Ports at this time.
21. With the 9/64 bit, re-drill the eight small holes you drilled in the sides, and countersink them.
38
You will get cleaner holes if you can drill straight through and into a piece of plywood or a board.
34
35
36
37
38
Summary of Contents for 1x8 Cabinet
Page 52: ......
