IRSC Plus
Technical Support:
11
Scenes
: makes it possible to enable and configure up to 4 different climate
scenes, or presets.
Timers
: allows configuring an automatic switch-off or switch-on of the A/C
system after a certain time.
Window Sensor
:
permits switching the A/C system off when a
n “open
window” signal arrives from the bus, in order to save energy.
Presence Detector
: permits switching the A/C system off when
a “no
presence detection” signal referring to the zone being acclimatised arrives
from the bus, in order to save energy.
All the aforementioned tabs are detailed next.
3.2
GENERAL PARAMETERS
As shown in Figure 5, from the
General Parameters
tab it is possible to configure the
main parameters of the A/C system to be controlled. These are the following:
Split Model
: sets a code (between 0 and 255) associated to the model of the
IR remote of the system to be controlled (please refer to the correspondence
table at http://www.zennio.com).
Min. Time set Between two Consecutive IR Messages
: allows establishing
a minimum time gap (in tenths of a second) between consecutive IR
commands sent from IRSC Plus to the A/C system (or split), thus restricting
the rate of these commands and ensuring the proper reception of all of them.
It is recommended to set a value of 20 tenths of a second.
Note
:
setting a value lower than this does not necessarily imply an
improvement in the performance, and may turn into communication issues
between the KNX system and the A/C system
.
Simplified Mode
: selecting this option brings the 1-bit communication object
"Simplified mode", which permits switching from the Cool to the Heat (working
modes easily (0=Cool, 1=Heat, or alternatively 0=Heat, 1=Cool). This option
