DALIBOX Broadcast 6CH/4CH
http://www.zennio.com
Soporte técnico:
http://support.zennio.com
35
ETS PARAMETERISATION
Once the option to customise the initial configuration has been enabled (otherwise, the
default configuration will be applied) the following objects will show in ETS:
Figure 19.
Channel “x”. Custom initialization
Initial Status
: sets the desired initial state of the channel:
“Last” (default value): when the KNX bus power is restored, the channel
will recover the dimming state previous to the bus failure. Note that this
option has no effect after a download (the channel will remain off).
“Off”: the channel will always start switched off.
“Defined Value”: the channel will start at a specific dimming level (between
0% and 100%), configured in “
Value
”.
Send Status
: if enabled, the status objects will be sent to the bus at the start-
up to inform about the initial state of the channel. This requires that the status
objects have been enabled (see section 2.2.6).
Delay
: sets a delay (in seconds) before performing this sending.
2.2.12
MODES
DALIBOX Broadcast 6CH / 4CH implements three special operation options (already
introduced in section 2) named as
Standby mode
,
Burn-in mode
and
Auto-Off
mode
, each of which is explained in detail next.
2.2.12.1
STANDBY MODE
The Standby mode can be enabled independently for each channel. When enabled,
DALIBOX Broadcast 6CH / 4CH sends a one-bit object to the KNX bus thirty seconds
after the channel is switched off. This allows making use of an external actuator to
