DALIBOX Broadcast 6CH/4CH
http://www.zennio.com
Soporte técnico:
http://support.zennio.com
11
During the Test On mode, a physical minimum (see section 2.2.2) of 3% will
be applied to all channels (thus, making the response of all ballasts
homogeneous).
The channel dimming through the on-board pushbuttons will be analogous
the that in the Test Off mode, with the following remarks:
A
short press
will cause immediate regulations to 0% or to 100% (and not
to the maximum level configured).
The
long press
dimming period will be 10 seconds (from 0% to 100%).
Any orders received from the KXN bus related to the channel operation will be ignored.
Moreover, the device will not send the status objects that may correspond to the
manual actions performed by the user.
The only exceptions are the lock objects
.
Important
:
the device is delivered from factory with both manual modes (Test Off and
Test On) enabled, although with all channels disabled (thus, the Test Off mode will
result functionless).
ETS PARAMETERISATION
After importing the corresponding ETS database and adding the device to the project
topology, the configuration process starts by right-clicking on the device name and
selecting
Edit parameters
.
The tab tree on the left shows the “General” tab in the first place. This entry itself
comprises the following parameters:
Figure 3.
General
