Zenith Data Systems MT2000, User Manual

Page: 78 / 205

4-25
Configuring Your System
Configuring I/O Riser Board Function Select Switches
This section describes how to configure and set the
function select switches for specific operating
parameters.
Caution: Before doing the procedures in this section,
make sure that your system is powered off and unplug
the AC power cord from the back of the chassis. Failure
to disconnect power before setting switches and moving
jumpers can result in personal injury and equipment
damage.
The function select DIP switches configure the modes
of your server. Figure 4-1 shows the DIP switches that
consist of a block of four switches, accessible on the I/O
panel that is located on the I/O riser board at the rear
of the chassis.
Figure 4-1. Function Select Switches and Dump Button
A
B
12
3
4
ON
DIP
A Function select switches
B Dump button