CoolSculpting® Elite
System User Manual
System Overview
CS-UM-CM3-02-EN-D
15
Top Cap Lip
When the applicator is resting on top of the control unit, the top cap lip helps keep the applicator in
place.
Access Panel
The access panel covers vents, a USB port, and the chiller tank cap (Figure 3):
•
Vents:
Vents provide airflow that reduces heat build-up inside the control unit. Ensure that all
vents are free from obstructions when the control unit is in operation
•
USB port:
The USB port (rectangular) is intended for use with approved software and hardware
provided by ZELTIQ.
Chiller tank cap:
The cap is for covering the coolant tank. A service technician is required
to add coolant to the system. Please contact customer service.
Figure 3: Rear of control unit with access panel removed
A: Vents
B: USB port (rectangular)
C: Chiller tank cap;
D: Product code and Serial Number
►
To remove the access panel:
Gently pull the tab at the top of the door toward you to disengage
the magnetic seal; then lift off the entire panel.
►
To replace the access panel:
Align the access panel with the recess and hold it close to the
control unit until the magnets snap it into place.
Power Receptacle and Power Switch
Do not use the Control Unit if the Power Switch, Power Cord and/or Power Receptacle become
damaged.
If the Power Switch, Power Cord and/or Power Receptacle appears to be damaged, contact
Customer Service as listed in the User Manual.
