35
ZCM3821-001_v01
●
Replace the frother nozzle in the milk frother and lock the nozzle by turning it 45° with
the rounded end of the measuring spoon.
●
Replace the lid
1
(pay attention to the direction).
●
Replace the milk frother in the coffee machine and push the lever downwards to lock.
●
Insert the end of the milk hose into the opening on the upper left of the milk frother until
it stops and press the milk hose into the guide.
●
Close the door of the coffee dispensing unit. When closing the door, the dispenser
should be located at the upper position, otherwise the milk tube will be jammed.
Recommended cleaning agents – accessories
The following accessories are available:
Milk sludge remover:
●
Urnex
®
Rinza.
Descaling liquid/tablets:
●
Durgol
®
Swiss Espresso,
●
BSH service accessories, No. 00311556.
Cleaning tablets:
●
BSH service accessories, No. 00310575.
Troubleshooting
This section contains important information on localising and eliminating faults.
In case of failure, the lights “cleaning”,
“descaling”, “empty grounds” and “refill
water” always lights up permanently.
COFFEE MACHINE MESSAGES, POSSIBLE CAUSES AND REMEDIES
Display
Cause
Remedy
●
Brewing unit soiled.
●
Remove the brewing
unit and rinse it thoroughly
with flowing water.*
●
Brewing unit not/or not
correctly fitted.
●
Insert the brewing unit
into the appliance and
close the door.*
●
Brewing unit overfilled.
●
Press
button,
the message “Brewing
unit soiled” is displayed.
Remove the brewing unit
and rinse it thoroughly with
flowing water.*
●
Grinding fineness is set
too fine or coffee powder
used is too fine.
●
Set a coarse grinding
fineness or use different,
coarser coffee powder.*
●
Water system is
calcified.
●
Run cleaning or
descaling programme.*
●
The water tank has
overflowed or is too damp.
●
Dry the water tank and
the water case thorougly.*
●
The water tank lid is
missing.
●
Remove the water tank
and put the lid on.*
●
Too much air in system.
●
Refill the water tank.*
●
Communication failure.
If one of these messages
are displayed, switch the
device off.
Switch back on again after
a cooling down phase of
approx. 30 minutes.
If the message is displayed
again, an error has
occurred that may need
a technical evaluation.
Please contact us fi rst via
the free service hotline:
801 005 500
22 20 55 259
If we cannot help you on
the telephone, you will be
instructed as to the further
procedure.
●
Input voltage error.
●
Main switch blocked.
●
Coffee temperature is
incorrect.
●
Brewing unit is blocked
(technical reason).
●
Use the splined opening
on the measuring spoon
to open the back of the
brewing unit with the
splined journal (min.
3 turns).*
* If your own remedies should not be successful, please also contact the service hotline.
