Zelmer Puris VC1260, User Manual

Page: 40 / 42

46
VC1260-001_v01
4 Turn the water tank upside down and unscrew the cap.
Fill the tank with water, replace the cap (make sure that it is
screwed all the way in) and refit the tank.
Do not use the steam mop with the steam
function with no water in the tank.
Plug in the unit to an appropriate outlet.
●
5
Slide the HEAT switch to the ON position.
6 The unit will start heating water. The HEAT indicator light
will illuminate.
When the STEAM indicator light illuminates
the unit is ready for operation with the steam
function.
7 To start operation, press and hold the trigger.
The mop will stop steaming when you release
the trigger.
If the unit runs out of water during operation,
slide the HEAT switch to the OFF position and
refill the water tank (see sections
4
and
5
).
When the micro-fibre cloth becomes very wet
or dirty, replace it with a clean and dry one.
The micro-fibre cloth becomes very hot when
using the steam mop. Use caution when
replacing.
In order to thoroughly sanitize an area of your
floor, wait 60 seconds for the unit to heat up,
then mop the selected area with a short forward
and backward motion for about 15 seconds.
8 After use, slide the HEAT switch to the OFF position and
wait until no steam is emitted from the cleaning head.
9 Empty the water tank and unplug the unit from the
outlet.
After use / Cleaning and maintenance
AFTER USE
When finished steam cleaning, make sure that the HEAT
●
switch is in the OFF position, then unplug the unit from
the outlet.
Pour out water from the water tank.
●
The micro-fibre cloths are machine washable (at max.
●
60°C).
If the cloths are very dirty, before washing soak
them in warm water with some detergent or
stain remover.
Thoroughly dry the cloths before storage.
●
REPLACING THE WATER SOFTENING FILTER
The water softening filter helps to remove minerals from water
which may impact the performance of your steam mop. How
often the filter should be replaced depends on how hard your
water is and how often you use the unit. We suggest that you
replace the water softening filter every 6 months or so.
The degree of filter contamination may impact
the performance of your steam mop.
Before replacing the filter, unplug the unit from
the outlet.
1 Remove the water tank (see the “STEAM FUNCTION”
section
3
).
2
Pull the filter up and remove it from the unit.
3 Replace the used filter with a new one. Press the new
filter so that it touches the unit base closely.
4
Refit the water tank.
CLEANING THE ELECTROBRUSH
Over time pieces of threads, strings, hair,
fabrics, etc accumulate on the roller of the
electrobrush. They impact the sweeping
performance and therefore the roller should be
periodically cleaned (at least once monthly).
Before cleaning the electrobrush, unplug the
unit from the outlet.
The roller of the electrobrush may be removed for thorough
cleaning.
1 Turn the roller lock located at the bottom of the cleaning
head to the position.
2 Remove the roller lock and the roller from the unit.
3
Using scissors or a sharp knife, carefully clean the roller
of the electrobrush. Using scissors or a sharp knife, cut hair
or threads rolled around the roller.
Be careful no to damage the bristle and the
roller of the electrobrush.
4 When cleaned, refit the roller.
5 Refit the roller lock and turn it to the position. The
roller is now locked.
DISASSEMBLING THE HOLDER AND
STORING THE UNIT
The holder is detachable for easy storage of the unit in low
cabinets.
1 Twist the upper cord wrap downwards.
2 Unwind the cord from the wraps.
3 Press the tube lock and slide out the tube with the holder
upwards.
C
G
E