Zelmer 986.6000, Instructions For Use Manual

Page: 30 / 32

30
Usage and regulation of the grinder
Before the first use, wash (see “CLEANING”) and dry a disassembled grinder, and then grind
around 50 grams of product (f. e. corns) - set-up the grinding option of the device with the medium
comminute. The grinded product is not fit to use cause it` s polluted and its necessary throw it away.
Important: Maximal time of uninterrupted work is around 15 minutes.
This condition is connected with maximal work time of machine, for which it should be done the 45
minutes of pause after 15 minutes of operation.
Important: The devices cannot operate without loading. Each time before staring the
device , fill it up with product.
Put the corns into the pan (8) , set up the handle of the body (3)
on the thicker grinding, set up the machine engine. The grinded
product will start pouring out through the hole.
Regulate the quern regulator (2) , depending of the demanded
grinding level or using seeds, with the handle of the body for
obtain the product with the adequate granulation level.
By turning it clockwise you will get the fine grind product. By
turning it counter-clockwise – the thick grind product.
The finest (minimal) grinding level is achieved by setting it up
with the handle on the line 1, and the hugest (maximal) by
setting it up with the handle on the STOP line. See the graphic
on the body (3) and quern regulator (2) .
Too strong twisting or turning of the handle out of STOP line during the work time can cause
the device failure.
Caution: It` s recommended to set the quern regulator during the grinder work time
between the line 1 and STOP line.
Important: It`s FORBIDDEN to use the REVERSE function in the machine when the grinder
is installed.
Caution: Remember about the accurate washing the grinder before grinding of the different
products. It will permit to avoid the mutual penetration of odors.
Caution: For the soft corns as oat or linseed it`s necessary to select the coast-grained
set up.
Cleaning and Maintenance
The grinder does not requires the cleaning after each operation (if it`s grinded one kind of product), cause
the worm prevents falling the seeds residues into grinder. Dry the steel quern (4, 5) using a soft cloth after
cleaning to prevent corrosion. In case of long-term storage, conserve the quern by greasing them (you
can use edible oil). Do not immerse the quern into boiling water. Don`t immerse them in the boiling water.
The part of plastic (don`t containing the graphic) can be washed in the dish-washer (max. of 60°C).