User’s Manual
27
ZEKA LP
f
set thickness of wide dot stripe. Allowed values 2..10, where the value
should be greater than the upper parameter. For some barcode standards
this values is ignored.
g
Barcode height in dots. Allowed values 24..1000.
h
Duplicate the information in text form:
N
– no,
B
– yes.
i
non obligatory parameter, that shows the alignment of duplication text
towards barcode, allowed only when previous parameter has value
B
.
Values:
C
– centered,
R
– right aligned. By default the text is left aligned.
j
Data to be printed. The format is same for text and barcode formation
and is described bellow. When the barcode works with determined
character set, the command will be cancelled if unallowable character is
used. Same is true for invalid length of barcodes that require certain
amount of characters.
Example
:
B0,0,0,E30,2,3,60,B,”123456789012”
will create image of EAN13
barcode with starting co-ordinate (0,0), not rotated, stripe thickness 2 dots,
height 60 dots, with duplication text and contents “1234567890128” (8 in this
case is generated by the printer check sum).
7.3.3. DRAW 2D BARCODE (PDF417)
The command draws 2D barcode. Only PDF417 is supported.
format:
bp1,p2,p3,p4,p5[,pi...],”Data”
p1
X-co-ordinate of upper left corner: from 0 to 1023.
p2
Y- co-ordinate of upper left corner: from 0 to 1023.
p3
Barcode type - should be ‘P’ for PDF417. MacroPDF and ECI
(Extended Channel Interpretation) are not supported.
p4
Maximal printing width in dots - 0 to 384.
p5
Maximal printing height in dots - 0 to 1024.
The following arguments are not compulsory. If not set the default values
are used. Each argument is selected with one letter:
p6 (s) Error correction level (ECL). Allowed values are s0 – s8. Levels 6, 7
and 8 are not supported – equalized to 5. If not set the correction level is
calculated by following chart: