Zeiss S100/OPMI pico, Instructions For Use Manual

Page: 108 / 278

Preparations for use S100 / OPMI pico
Version 7.0
Page 108 G-30-1781-en
Connections
Connecting the S100 floor stand
• Ensure that the rated voltage indicated in the display window (3) (only for
halogen/xenon) corresponds with the rated voltage for the network at the
site of the installation.
• Ensure that the unit has been switched off at the power switch before
plugging in or unplugging connectors at the power input socket (4).
• Make sure that power switch (1) is OFF.
• Plug the supplied power cord on the supply unit into the power inlet sock-
et (4).
• Connect the power cord via a socket to the power supply system.
CAUTION Risk of electric shock caused by inadmissible or defective accessories!
Inadmissible or defective accessories may lead to increased leakage current!
• Never touch any power outlets or video ports during patient contact.
• When setting up your system, make sure to comply with the require-
ments of IEC 60601-1:2005, chapter 16; in some countries IEC 60601-1-
1:2000 may still be valid.
• Also comply with the Medical Device Operator Ordinance or other na-
tional codes.
NOTE Risk of tripping!
Inappropriate routing of cables increases the risk of tripping.
• Always run cables in a manner that will not impede the user's move-
ments.
CAUTION Risk of electric shock
Risk of electric shock for operator and patient if cables and plug connections
loosen and if housing parts are under voltage.
• Only connect the power cord using a socket with proper protective earth
connection.