to the right in correct fit fold,
downward attack taps to mount leave.
•
Knurled thumb screw tighten (to the work with DF condensor lens 1.2
►
(14)
Change against aplanatischen condensor lens 0,9
One proceeds in a general manner, how under (21) described, in place of the condensor lens upper section becomes the entire
condensor lens ausge exchanges.
Change against achromatic condensor lens head 1.3
►
(21) (of 26) changes of the halogen bulb 6 V 25 W
Switch light off, pull power supply plugs!
Knurled thumb screw at the light rear wall loosen, light en off clothes to the rear take. Thus the lamp becomes accessible.
Knurled thumb screws to both sides of the lamp piston loosen and lamp out as well as mother board take.
Spare lamp on mother board into the slots of the lamp admission push in. Mother board in such a way align that it both sides on the
noses of the ceramic lamp admission mount and one of the noses comes to lie into the notch of the carrier base. Knurled thumb
screws wedge. Note! Quartz flasks of the lamp directly with the fingers do not affect (pistons with white spirits clean if
necessary!)
Light lining postpone and with knurled thumb screw fix. Power supply plugs attach, light on switch.
(27)
The object marker
Without having to give the attitude up of the image definition, object details can be marked, which are to be regained later problem-free.
The object marker sits like an objective at the lens turret. It contains three fiber donates. The interesting preparation place is marked by
three points. The points are because of the corners of a equivalent lateral triangle with 4 mm of edge length, which describes the place
drawing to knowing. The marker is seen to middle objectives priority for the work with weak to pre.
Install:
Knurled ring at the upper end of the marker unscrew. Ge slit cover plate with screwdriver or suitable coin unscrews. Outer sleeve
of the marker in such a way turn that a constant slot develops. The marker contains 2 spiral springs; the upper (stronger) out
take.
Schutzdeckel of the fiber pin cartridge remove, cartridge in indie case of the marker push: Fiber pins toward the eccentric cam,
cartridge-handles into the slot. The cartridge sits correctly, if their handles at closed end of the slot fastens. Strong spiral spring
into the gap between cartridge and case insert. Slit cover plate to attack screw in. Knurled ring to attack screw on.
Markers with the left hand at the eccentric cam touch, hand have the cartridge with the thumb of the right hand toward knurled ring
to press, cartridge to attack in the marker case turn and handle release. With correct work the hole must be locked in the
baseplate of the eccentric cam now.
Object markers to attack into an eye of the objective of gun screw in. Object markers in working position
bring and straight so far again unscrew, until the eccentric cam cartridge-handles to the rear and forward
points. Markers in this position with knurled ring more anObjektivrevolver clamp.
Mark:
Marking object place into the center of the field drive
