Zeiss Axio Examiner, Operating Manual, Page: 32 / 96

START-UP
Carl Zeiss Installing standard components Axio Examiner
32 M60-2-0003 e 05/2012
If the adapter is used for expanding the specimen area (430030-9100-000), push the objective
mount or objective nosepiece against the upper stop screw (Figure 3-9/
1 ).
The control cable (Figure 3-10/
1
) needs to be
connected in order to take advantage of
automatic lens recognition when the 2x
objective mount cod. (424516-9020-000), or
the 4x objective nosepiece cod. (424516-
9030-000) is used at a motor-operated lower
microscope part.
3.1.8 Screwing in objectives
•
Use the shift knob (Figure 3-11/ 1 ) to move the
objective mount or objective nosepiece into the
WORK position.
•
Take the dust caps, if any, out of the
corresponding openings at the objective mount
or objective nosepiece.
•
Take the objective(s) (Figure 3-11/ 3 ) out of their
container, and screw them into the objective
mount or objective nosepiece. Use an objective
adapter (Figure 3-11/
2 ) if required.
Use only the objectives as indicated for the
following microscope top parts (also see the
System Overview on page 19 and the
following):
Axio Examiner.A1 Axio Examiner.D1 Axio Examiner.Z1
all 45 mm objectives all 75 mm objectives all 75 mm objectives
all 45 mm objectives with 11 mm
adapters for DIC procedures
all 45 mm objectives with 30 mm
adapters
all 45 mm objectives with 30 mm
adapters
70 mm W Plan-Apo 20x
(no DIC possible)
Figure 3-10 Connecting the objective mount or
objective nosepiece cod.
Figure 3-11 Screwing in objectives