Zcom WS5G2, User Manual

Page: 50 / 78

Hyperion Series Wireless LAN Controller User Manual
58-150008-IQN_V1.0 Page 47
These parameters in [Thin AP Configuration > Bandwidth Control] page are described in details as following:
Parameter Description
Bandwidth Control Mode Select UE MAC , i.e., using the MAC address of user endpoint as the client
identifier to control its bandwidth.
Default User Bandwidth If “Bandwidth Control Mode” is enabled with UE MAC , each user client will
reserve a default bandwidth of 64×64kbps (i.e., 4Mbps) for uplink and
downlink. This default value can be changed by customer, click <
Apply >
button to accept this change.
Radius Policy First If this switch is enabled, the preferred policy of bandwidth control is from
Radius, otherwise, is from here that locally configured.
User Bandwidth Control Based on
MAC
Here configuring the local policy of bandwidth control based on user client
MAC:

MAC Address: Enter the MAC address of user client to which you want
to apply the bandwidth control.

Uplink Bandwidth: The data transmitting bandwidth of the user client
corresponding to this MAC address.

Downlink Bandwidth: The data receiving bandwidth of the user client
corresponding to this MAC address.
Bandwidth Control Policy List

Click < Add > button to append this new policy to the list.
Click the Edit button to modify the policy in the list.
6.6. AP L
ICENSE
WLC uses AP License file to control the capacity of thin AP in Wi-Fi system. If the WLC has been installed on-site, the AP
License file must be imported to the WLC immediately; otherwise, many thin APs cannot access to WLC except the
default few. The AP License file is created and delivered by the WLC vendor.
Select
[Thin AP Configuration > AP License] in the menu to enter the configuration page as following:
Figure 6-10 Bandwidth Control Configuration Page
Click the < Browse > button to select the AP License in the directory of local host, then upload it into WLC.
These parameters in
[Thin AP Configuration > AP License] page is described in details as following:
Parameter Description