Zcom WS5G2, User Manual

Page: 46 / 78

Hyperion Series Wireless LAN Controller User Manual
58-150008-IQN_V1.0 Page 43
These parameters in
[Thin AP Configuration > Wireless Profile] page is described in details as following:
Parameter Description
Profile Name Give a mnemonic name for the new profile to simplify the management of system
configuration.
Country/Region Select the Country/Region code for where the Wi-Fi system is deployed. The
authorized Wi-Fi channels vary in different country/region because of different law
regulation.
Wireless Mode Select an IEEE 802.11 specification for the thin AP. The available specifications are:

11n - Thin AP operates under the 802.11n specification in the 2.4GHz band.
The air interface data rate is 600Mbps.

11ac - Thin AP operates under the 802.11ac specification in the 5GHz band.
The air interface data rate is 1Gbps.

11ax(2.4GHz) - The radio module in dual-band AP operates under the IEEE
802.11ax specification in the 2.4GHz band. The air interface data rate is
10Gbps.

11ax(5GHz) - The radio module in dual-band AP operates under the IEEE
802.11ax specification in the 5GHz band. The air interface data rate is
10Gbps.
HT Mode HT (High Throughput) is a bandwidth aggregation technology derived from
802.11n. The latest 802.11 specification supports multiple HT modes, including
HT20, HT40, HT80 and even HT160, which are integer multiples of the 20MHz
bandwidth. The larger the suffix number of HT, the higher the data rate of the air
interface.
MIMO Multiple input multiple output technology, which uses independent Tx and Rx paths
in the air to achieve spatial stream multiplexing. The maximum number of MIMO
for 802.11n is 2, for 802.11ac is 4, and for 802.11ax is 8.
Channel Selection Configure the channel selection policy of the thin AP:

Manual - Set the operating channel and band manually for current AP
group.

Auto Channel - The operating channel and band of the thin AP in current
group will be automatically selected according to the policy configured in
[
AP Configuration > Optimization ] which is globally effective to the thin
APs in all groups.
Channel / Frequency If Manual mode is selected in above “Channel Selection”, then manually set its
operating channel and corresponding frequency here.
TX Power Mode Configure the radio transmit (TX) power adjustment policy of the thin AP:

Manual - Manually set the radio TX power for the thin AP in current group.

Auto Power - The transmit power of the thin AP in current group will be
adjusted automatically according to the policy configured in [ AP
Configuration > Optimization ] which is globally effective to the thin APs
in all groups.