ZBA ZB-3062, User Manual

Page: 76 / 89

ZBA Inc.
76
1.) at least fourteen characters long,
2.) whose first four characters are the letters “ISBN,”
3.) whose last character is a check character, and
4.) when the modulo 11 check character “0123456789X” is programmed.
Please note that all these commands can be combined into a single serial programming command:
OCRENA2,TMP”ISBNggggggggggggctCdddd hdddEtCdddd
hddddE”,GPG”0123456789-”,GPH”P\”,CHK”0123456789X”.
These commands can be encoded into the following Aztec Code symbol:
OCR Template Codes
Note: Reading more than three rows of OCR is not recommended. Contact the factory if you have an application that requires reading four or more rows of
OCR.
OCR Template Codes
On
Enter User-Defined
Variable ”h”†
Enter User-Defined
Variable ”g”†
Exit Selections
Save OCR Template
Discard OCR Template
9.7 Utilities
To Add a Test Code I.D. Prefix to All Symbologies
This selection allows you to turn on transmission of a Code I.D. before the decoded symbology. This action first clears all current prefixes, then programs a
Code I.D. prefix for all symbologies. This is a temporary setting that will be removed when the unit is power cycled.
Show Software Revision
Scan the bar code below to output the current software revision, unit serial number, and other product information.
Show Data Format
Scan the bar code below to show current data format settings.
Resetting the Standard Product Defaults
If you aren’t sure what programming options are in your imager, or you’ve changed some options and want the standard product default settings restored,
scan the Standard Product Default Settings bar code below.
The Menu Commands starting on page 11-5 lists the standard product default settings for each of the commands
Test Menu