ZBA ZB-3062, User Manual

Page: 13 / 89

ZBA Inc.
13
5.1 Reading Skills
The engine has a view finder that projects a bright red or green aiming beam that corresponds to the engine’s horizontal field of view. The aiming beam should be centered
over the bar code, but it can be positioned in any direction for a good read.
The aiming beam is smaller when the engine is closer to the code and larger when it is farther from the code. Symbologies with smaller bars or elements (mil size) should be
read closer to the unit. Symbologies with larger bars or elements (mil size) should be read farther from the unit. To read single or multiple symbols Linear bar code 2D
Matrix symbol (on a page or on an object), hold the engine at an appropriate distance from the target, send a trigger command, and center the aiming beam on the symbol. If
the code being scanned is highly reflective (e.g., laminated), it may be necessary to tilt the code +5° to prevent unwanted reflection.
6 Programming the ZB-3062
ZB-3062 Series Scanner
To program the ZB-3062, you must scan a series of programming barcodes in the correct order. On the last page of this manual you will see a table of alphanumeric
barcodes, which are used to program the various options as peer your application needs.
To program each option, you must:
1. Scan the Program barcode on the parameter setting part.
2. Enter the option mode by scanning the option barcodes (also on the Parameter setting part).
3. To the right of the option barcode, the necessary alphanumeric inputs are listed. Scan these alphanumeric entries from the Program Chart . To confirm
above steps, you must scan the Save barcode.
.