zaxe X3, User Manual

Page: 3 / 56

Warnings
3
Power Source should be 230 VAC/ 50
Hz(EU) or 110 VAC / 60 Hz(US); do not plug
your printer to any other power sources
then these as it may cause serious damage
to your device
As it will affect the printing
quality please set your printer on
a flat and well balanced surface.
Hot surface! Wait for the table
to cool down before touching.
While placing the Magnetic PEI plate be
careful not to damage the electronic traces.
It might case some serious harm to on your
device.
We recommend you set up a
well-ventilated room that is dedicated
only to 3D printing.
Please try not to stay in the same
room with the devices for a long
period of time. Vapors that are
produced while printing does not pose
a direct threat to your health but on
the long run when it gets combined
with the accumulated dust particles it
might pose a threat.
Tools in the starter kit box and
accessories for the intended use
should be used with special care.
Wrong use can cause serious injuries.
When you unplug the power cord,
pull the plug instead of the cable. It
will reduce the risk of damaging the
plug or the AC outlet.