1
Open the oven door
completely and find the
hinges linking the door to
the oven.
2
Unlock and turn the
small levers located on the
two hinges.
3
Handle the door by its
left- and right-hand sides,
then slowly turn it towards
the oven until it is half-
closed. Gently pull the
oven door off its site and
place it on a steady plan.
Clean the oven door glass with warm soapy water and a
softh cloth only. Never use harsh abrasives. Once the
cleaning is carried out, refit the oven door, following the
procedure in reverse.
Stainless steel or aluminium appliances:
We recommend that the oven door is only cleaned using
a wet sponge and dried after cleaning with a soft cloth.
Never use steel wool, acids or abrasive products as they
can damage the oven surface. Clean the oven control
panel following the same precautions.
Warning! DO NOT clean the oven door while the
glass panels are warm. If this precaution is not
observed the glass panel may shatter.
If the door glass panel becomes chipped or has deep
scratches, the glass will be weakened and must be
replaced to prevent the possibility of the panel shattering.
Contact your local Service Centre who will be pleased to
advise further.
Replacing the oven light
Disconnect the appliance from the electrical supply.
If the oven bulb needs replacing, it must comply with the
following specifications:
• Electric power: 15 W/25 W;
• Electric rate: 230 V (60 Hz);
• Resistant to temperatures of 300°C;
• Connection type: E14.
These bulbs are available from your local Service Force
Centre.
To replace the faulty bulb
1. Ensure the oven is isolated from the electrical supply.
2. Push in and turn the glass cover anticlockwise.
3. Remove the faulty bulb and replace with the new one.
4. Refit the glass cover and restore the electrical supply.
Grill heating element
This model has been fitted with a hinged grill element to
make the roof of the oven especially easy to clean.
Warning! Before proceeding ensure the oven is cool
and disconnected from the electricity supply.
1
Undo the screw fas-
tening the grill element.
When carrying out this op-
eration for the first time,
we recommend using a
screwdriver.
2
Then gently pull the
grill downwards to allow
access to the oven roof.
17
