Downloaded from www.vandenborre.be
Before first use
Warning! Refer to "Safety information" chapter.
Remove all packaging, both inside and outside the
oven, before using the appliance. Do not remove the
rating plate.
Caution! To open the oven door, always hold the
handle in the centre.
Initial Cleaning
• Remove all parts from the appliance.
• Clean the appliance before first use.
Caution! Do not use abrasive cleaning agents! This
can damage the surface. Refer to chapter "Care and
Set an oven to maximum temperature and run an empty
oven for 45 minutes, to burn off any residue from the cavi-
ty surface. Accessories can become hotter than in normal
use. During this period an odour can be emitted. This is
normal. Make sure the room is well ventilated.
Hob - Daily use
Warning! Refer to "Safety information" chapter.
Ignition of the burner
Warning! Be very careful when you use open fire in
kitchen environment. Manufacturers decline any
responsibility in case of misuse of the flame.
Always light the burner before you put the cookware
on it.
To light the burner:
1. Push and hold the spark generator button .
2. Turn the control knob counterclockwise to the maxi-
mum position . Push the knob in and hold.
3. Release the spark generator button but keep the con-
trol knob on this position for approximately 10 sec-
onds; this will let thermocouple to warm up. If not,
the gas supply will be interrupted.
4. Adjust the flame after it is regular.
If after some tries the burner does not light, check if
the crown and its cap are in correct positions.
1
2
3
4
1
Burner cap
2
Burner crown
3
Ignition candle
4
Thermocouple
Warning! If the burner does not light after 10
seconds, release the control knob, turn it into off
position and try to light the burner again.
Important! You can light the burner without electrical
device (e.g. when there is no electricity in the kitchen). To
do so, put the flame near the burner, turn the related knob
to the maximum gas release position and push it down for
10 seconds.
If the burner accidentally goes out, turn the control
knob to the off position and try to light the burner
again after minimum 1 minute.
The spark generator can start automatically when
you switch on the mains, after installation or a pow-
er cut. It is normal.
Turning the burner off
To put the flame out, turn the knob to the symbol .
24
