ZANKER KOP37902XK, User Manual

Page: 22 / 60

3. Close the oven door halfway to the first opening
position. Then lift and pull forward and remove the
door from its seat.
4. Put the door on a soft cloth on a stable surface.
5. Hold the door trim (B) on the top edge of the door
at the two sides and push inwards to release the
clip seal.
1
2
B
6. Pull the door trim to the front to remove it.
7. Hold the door glass panels by their top edge and
carefully pull them out one by one. Start from the
top panel. Make sure the glass slides out of the
supports completely.
8. Clean the glass panels with water and soap. Dry
the glass panels carefully. Do not clean the glass
panels in the dishwasher.
When the cleaning is completed, install the glass panels
and the oven door.
Make sure that you put the glass panels (A and B) back
in the correct sequence. Check for the symbol / printing
on the side of the glass panel, each of the glass panels
looks different to make the disassembly and assembly
easier.
When installed correctly the door trim clicks.
A B
Make sure that you install the middle panel of glass in
the seats correctly.
A
B
Replacing the lamp
Warning! Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
Caution! Always hold the halogen lamp
with a cloth to prevent grease residue
from burning on the lamp.
The back lamp
1. Turn the lamp glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C heat-
resistant lamp.
4. Install the glass cover.
22