- 29 -
on the laser controller display panel.
When the current temperature reaches close to the set temperature,
then push LDD button. When the LDD current (LD Current in HOME)
reaches the set value, push the Q-SW button.
Important:
Do not perform any operations when the Alarm indicator (red
light) on the laser controller panel is on. Wait till the red light is off before
attempting to operate the laser controller.
Tips:
If the red light does not turn off, please shut down the laser system
and restart it after 10 seconds. Please contact Z Rapid technical support if
the red light continues to be lit.
Note:
The key-switch enables (ON) and disables (OFF) all the buttons,
except Power on the panel.
b)
Turn off the laser
On the laser controller panel, push the QSW button to turn it off.
Push the LDD button.
Wait till the value of LD current is 0 then rotate POWER to the off
position.
2. Self-Test
The system performs a self-test automatically when the laser starts up.
