9
Submenu Other:
DRL and other lighting options
• Set AUX:
This setting is to configure the
vehicle for AUX button package.
• Set Blind Spot:
This setting is to
configure the vehicle for blind spot
detection package.
• Set Belt ding:
This setting is to delete
the seat belt reminder chime. The
reminder icon will remain on the dash.
Always wear your seatbelt!
• Set ParkSense:
This setting is to
change or disable ParkSense system.
Choices are as follows:
0: None
1: Sahara
2: Rubicon
• Set Splash:
With this setting you can
choose the cluster splash screen. For
Wranglers:
Sport
Sahara
Rubicon
For Gladiators:
Sport
SportX
Rubicon
• Set DualZone:
With this setting you can
allow the use of the single zone or dual
zone center stack button assembly.
Useful when upgrading from a 5” radio
to 7 ot 8.4, and swapping in the dual
zone controls that come with volume
knobs. Note: the system will still be
single zone in this case, only the driver
controls will change the temperature.
• Set Auto Headlights:
Enable the
factory automatic headlight assembly
• Set Panic:
With this setting you can
choose whether the PANIC button on
the keyfobs will be enabled or not.
This needs to remain enabled for the
Tazer JL Mini JL hood alarm feature to
function.
• Firmware Version Display:
Shows the current Tazer JL Mini firmware revision.
• Serial Number Display:
Shows your Tazer JL Mini’s serial number for (only needed
in specific tech support situations)
• Unmarry Key:
Displays the current one-time use Unmarry Key.
• Full Reboot:
Will reset vehicle modules and the Uconnect system twice. This takes 2.5
minutes to complete and should be performed after any Vehicle Settings are changed –
Uconnect will reboot twice, the dash will reset, and when it’s finished, the red security dot
on the dash will turn on and back off. Once complete, shut off the vehicle, open and close
the driver door and wait for a minute to be sure the dash turns off.
