11
Non-Menu Live Settings
Some
live
functions of the Tazer JL Mini are
not accessed via a menu
, but rather work
automatically or with
button presses
.
• Light Shows:
The Tazer comes pre-
configured with 6 light shows out of the
box, plus 3 “make your own” light shows
that you can configure with the ZPU
utility. There are two ways to control the
light shows on the Tazer:
Keyfob:
The light show can be
turned on by pressing unlock-unlock-
lock-unlock from the keyfob. This
will start the first light show in the
sequence (depending on which show
it’s configured to start with). Pressing
unlock again will advance to the next
enabled show. Pressing lock will turn
off the light shows. You may lock
the vehicle while the shows are on
by pressing the button on the door
handle or using the key.
Dash Menu:
You can start the show
by setting the dash to “Audio” mode,
then press the left arrow and tap
cruise CANC button. “Lightshow?”
will display on the dash. Hold left
arrow and tap cruise on/off (center)
button to turn on the first light show
in the sequence. Again to advance
to the next show. Exit the menu
(left arrow and CANC) to turn off the
show.
• Start/Stop Kill:
Set the Start/Stop
system as you wish, enabled/disabled,
and the Tazer JL will set it that way then
next time you start the vehicle.
• Traction Kill:
Set the traction control
system as you wish, enabled/disabled,
and the Tazer JL will set it that way then
next time you start the vehicle.
• Sway Bar in 2WD:
Press the Sway
bar button while in 2WD and it will
disconnect or re-connect as if it were in
4WD. It will automatically re-connect at
30MPH and disconnect when the Jeep
comes back to a full stop. See “SwayKill”
in Button Remap section for full sway bar
control.
• Locker Control:
Press the REAR locker
button in 2WD/4HI or the FRONT/REAR
button in 4HI while under 10mph and
lockers will engage. Press the Locker
OFF button to disengage lockers. This is
the same method to operate the lockers
as if in 4LO. See LOCKERS in Button
