6
After unmarrying, advance to the “full
reboot?” option and select it, allowing a
full
2.5 minutes
for the Tazer JL Mini to
reboot all systems – the Uconnect will
reboot twice in this time, the dash will
reset, and when it’s finished, the red
security dot on the dash will turn on and
back off.
A few sleep cycles might be
required for all changes to take effect.
Select “UNMARRY” to
return the vehicle to stock.
• Light Shows:
Activate pre-programmed
and custom light shows, even when the
engine isn’t running.
• Clear CELs:
Clear the check engine
light and diagnostic codes stored in the
PCM, TCM, ABS, and AWD modules.
• Display DTCs:
Cycles through
Diagnostic Trouble Codes
• Marry/Unmarry:
To advance to any
of the vehicle settings, you will first
need to “Marry” the Tazer JL Mini
to the vehicle.
When you select this
option, the Tazer JL Mini will download
your car’s
current
(presumably stock)
settings. This should take around 15
seconds.
Do not disturb this process.
Once complete, you will be able to
advance to the
Settings
choices.
• Submenus:
Once married, you can
advance though several sub-menus.
Select a submenu using the method
described above.
Submenu Perf:
performance-based options
• Set Tire Size:
Use this setting to change
the calibration for tire size. Use the left
arrow and /- buttons to raise or
lower the value, then select it (left arrow
and cruise on/off) to save the new setting.
• Set Gear Ratio:
Use this setting to change
the calibration for axle gear ratio. Use the
left arrow and /- buttons to raise
or lower the value, then select it (left arrow
and cruise on/off) to save the new setting.
• Set Transfer Case LOW ratio:
Use this
setting to change the calibration for 4LOW
gear ratio. Use the left arrow and cruise
+/- buttons to raise or lower the value,
then select it (left arrow and cruise on/off)
to save the new setting.
The
setup menu
is accessed with the
ignition ON but engine NOT running.
The menu items are listed in the order in which they will display.
