Switch Wiring
4
16
Check out how polar patterns
work on the following page.
Now let's do the same for the switch PCB by wiring
the pattern, low-cut and pad selectors:
Cut and strip seven pieces of wires to
appropriate lengths.
Wires should run from the front of PCB B to the
back of PCB C.
Wire point OMN of PCB B to PAT 1 of PCB C,
CRD to PAT 2 and 8 to PAT 3.
Repeat for the PAD points of PCB B to PAD 1 and
PAD 2 of PCB C.
Repeat for the LC points of PCB B to LC 2 and LC
3 of PCB C.
Make sure to twist each set of
wires together as tighlty as
possible to prevent any noise.
The orientation of LC and PAD
wires does not matter here.
Make sure you leave enough
length to the wires when linking
the PCBs together in order to
facilitate any troubleshooting
later on.
~ Build Notes ~
