4 8
y t
2.2 a //
Coupe les colliers rilsan avec une pince coupante.
2.2 b //
Enlève toutes les vis, graisse-les puis mets les de
côté (clé Allen 4 mm).
2.2 c //
Place les vis dans les brides puis attache-les
à la potence (clé Allen 4 mm). Les brides doivent être
correctement alignées.
2.2 d //
Serre d’abord les vis en bas des brides.
2.2 e //
Serre les vis du bas avec le couple préconisé avant
de serrer celles du haut. Il ne doit pas y avoir de fente entre
les brides et la potence en bas («zero gap»).
2.2 f //
Veille à une fente régulière entre les brides de
serrage et le corps de la potence et à un montage précis
et centré du cintre. Les lignes dessinées sur ces com-
posants t’aident. Le couple de serrage préconisé par le/
les fabricant(s) doit être respecté.
2 . 2
MONTAGE DU GUIDON – RENTHAL FATBAR CARBON 35
C
d
e
a
b
F
Summary of Contents for RTFM JEFFSY
