York TIWM006B22S, Installation And Maintenance Manual

Page: 11 / 50

P5417090
7
3.1 Combination of Outdoor Unit and Indoor Unit
The combination capacity of indoor unit against the outdoor unit is selected depending on the outdoor unit
capacity. Refer to “Installation and Maintenance Manual” for outdoor unit to decide the required combination
of indoor and outdoor units, and the combination unit capacity.
3. Before Installation
3.2 Transportation and Handling
(1) Transport the product as close to the installation location as possible before unpacking.
(2) Do not lay any objects on the indoor unit.
(3) Take care when handling the indoor unit. Rough handling of the indoor unit can damage the unit.
(4) The indoor unit handle is fabricated from foam polystyrene and is susceptible to breakage if any
excessive force is applied as a result of mishandling of the unit during installation.
(5) To avoid damage to the resin covers, cover it with cloth before lifting or moving the indoor unit.
(6) Do not move the louver by hand. If moved, the louver mechanism will become damaged.
NOTES:
Comply with the following when using the wireless controller (CIR01).
● The built-in receiver can be used only for a single operation and individual operations for twin, triple and
quad combinations. However, it cannot be used for the following operations:
* Operation with 2 Controllers (CIR01 and wired controller CIW01)
This is because the switch “SW2” on the DIP Switch PCB must be “WIRED” when using CIW01.
* Simultaneous Operation of Multiple Units
● When using the wireless controller (CIR01) for simultaneous operation for twin, triple and quad
combination, the optional receiver kit (CWDIRK01) is required.
● The "Dual Setpoint Operation" and "Setback Operation" are not available from the wireless controller
(CIR01).
3.3 Factory-Supplied Accessories
(1) Check to ensure that the following accessories are packed with the indoor unit.
inch (mm)
Accessory
Qty.
Purpose Usage
006 to 012 Type 015 to 030 Type
Mounting Plate 1 1
For Mounting
Indoor Unit
Refer to Section 5.
Screw
M4 x 1L (25L)
6 8
For Securing
Mounting Plate
Screw
M4 x 9/16L (40L)
2 4
Pipe Insulation 1 1
For Refrigerant Piping
Connection
Refer to Section 6.2.
PVC Tube 2 2
For Separating
Communication Cables
and Wired Controller
Cables from Power
Supply Wirings
7/16 ID (11 ID)
Refer to Section 8.4.
Cable Band 5 5
Logo Label 1 1
Logo Label for
HITACHI Brand
Refer to the
instruction paper
attached together with
the logo labels.
Logo Label 1 1
Logo Label for
YORK Brand