York MILLENNIUM YCUL0016SC, Assembly, Installation, Operation & Maintenance

Page: 168 / 172

YORK INTERNATIONAL
168
ISOLATOR INSTALLATION AND ADJUSTMENT
TYPE CP MOUNTING
Mountings are shipped completely assembled, ready to
install.
1. Locate mountings under equipment at positions
shown on tags or on VM layout drawings, or as
indicated on packing slip or correspondence.
2. Set mountings on subbase, shimming or grouting
where required to provide flat and level surface at
the same elevation for all mountings (1/4" maxi-
mum difference in elevation can be tolerated). Sup-
port the full underside of the base plate - do not
straddle gaps or small shims.
3. Unless specified, mountings need not be fastened
to floor in any way. If required, bolt mountings to
floor through slots.
4. Set the machine or base on the mountings. The
weight of the machine will cause the upper hous-
ing of the mount to go down, possibly resting on
the lower housing.
5. If clearance “X” is less than 1/4" on any mounting,
with wrench turn up one complete turn on the ad-
justing bolt of each mounting. Repeat this proce-
dure until 1/4”, clearance at “X” is obtained on one
or more mountings.
6. Take additional turns on all mountings having less
than 1/4” clearance, until all mountings have at least
this clearance.
7. Level the machine by taking additional turns on all
mounts at the low side. Clearance should not ex-
ceed 1/2" - greater clearance indicates that
mountings were not all installed at the same eleva-
tion, and shims are required. This completes ad-
justment.
FIG. 23 – TYPE CP MOUNTING
LD03837
Appendix 1