-26-
This system is the hand-held air tool for the purpose of not only tightening
the bolt, nut, screw etc. with low vibration and low noise level, but also
managing the tightening torque precisely.
Warning & caution for using system wrench (tool, controller) safely.
■
Using the pneumatic tool for any applications
other than those specified could result in serious
accidents. To avoid that, be sure to thoroughly
read this Instruction Manual and fully understand
the instructions before use to insure proper use.
■
Precautions before use:
About the tool
●
Use under the consistent air pressure within 0.4MPa
~0.6MPa (the dynamic air pressure with the gauge of
air piping at free speed)
●
Be sure to install a regulator / an air filter / a lubricator.
●
Do not easily change the air pressure, setting values,
adjusted position of the adjustment screw, usage envi-
ronment etc., initially set up at the installation.
When changing, make sure without fail to confirm the
torque.
●
Use air hose with the specified inner diameter.
Usage of air hose with other than specified size can lead air
flow to be short or over, which can cause work failure.
About the controller
●
Handle the controller carefully.
Rude handling causes the accident or failure. Do not give
the impact by throwing or dropping.
●
Usable temperature is 5
℃〜
40
℃
and humidity is 35
〜
80
%
.
Avoid the usage in the place with direct sunlight, dust or
corrosive gas.
●
Be careful not to get the electric shock, when plugging
the controller in. Also do not do the job with wet hand.
WARNING
WARNING
CAUTION
Summary of Contents for YED-90
